Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

How to Solve the “Naming Error” in the LVS

Status
Not open for further replies.

weiTan

Newbie
Joined
Aug 3, 2019
Messages
1
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
9
Dear All

捕1.PNG
I check the net9 in the layout --------------------(1)
I check the PWM_B,X123/PWM_B in the source--------(2)

(1)(2)is same.
Q:where is the error? Thanks!
 

You have a number of discrepancies. Start with fixing your port error.
 
  • Like
Reactions: weiTan

    weiTan

    Points: 2
    Helpful Answer Positive Rating
Hello! Usually if in layout name 1 net and in source name - 2 nets , it means that you shorted PWM_B,X123/PWM_B. Have a look carefully, may be you put extra some vias.
As life huck you mean put some pin (for exapmle "name1") on net PWM_B and pin "name2" on net X123/PWM_B and then LVS will see shorts and it will be easier to find short.
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top