Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

A measurement issue in Signal generator and Spectrum Analyzer

Status
Not open for further replies.

Anomis

Junior Member level 3
Joined
Mar 11, 2017
Messages
29
Helped
5
Reputation
10
Reaction score
4
Trophy points
3
Location
South Korea
Activity points
294
Hi all,
I need a help for this stuff:
20190802_003245.jpg
I set 10 dBm for output signal @ 2.5 GHz by Signal generator (Agilent E4438C), however my spectrum analyzer shows up the level of above 15 dBm. I already tried to adjust Reference level and RBW/VBW but it happens to be like not any right sense. Could anybody know it ? please leave an explaination.
Thank you,
 

ALC is OFF , try with ON .. Signal Generator may have a calibration error or both..
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top