AlexKeys
Newbie level 2
I have followed the steps at from the Xilinx page up until the point that I had to run the GUI. I imported the said files, booted the Zynqboard with that data. However, the buttons "StartMasterPTP" and "StartSlavePTP" do not work.
Things I did not do:
Also, the document says that the project is obsolete. Does that imply that it won't work with my 2018.3 vivado? Has anyone been able to make it work? I would greatly appreciate it
Things I did not do:
- I did not run the Linux kernel building part: I guessed that was optional especially since I used the files they provided.
- I did not use two boards: With this, I was told that using the PC and one Zync board should suffice (I am not sure though. Clarity on this, if it is not so would be greatly appreciated)
Also, the document says that the project is obsolete. Does that imply that it won't work with my 2018.3 vivado? Has anyone been able to make it work? I would greatly appreciate it