furkan38
Newbie level 1
Hi Everyone,
I am trying to simulate simple 1 turn coil to see the magnetic field created at the center of the coil on CST simulation tool. The steps I followed are as below;
- I created a single turn coil which has 10cm diameter in low frequency domain.
- Then I cut very small part of it, and added current path with 1Amp.
- I select wire crosssection radius as 1cm.
- Then complated mashing and boundry things
- Later I simulated with 20khz.
The formulation to calculate magnetic field created at the center of coil is (Uo*I)/2*r
When I take Uo as 4*pi*10^(-7), I= 1amp, and r=0.05 meters I got the result of 12.566*10^(-6)
But when I run the simulation, I see that magnetic field created at the center is 9.03*10^(-6).
I attached the simulation file, please help me to find what could be the reason having different results.
Thank you
I am trying to simulate simple 1 turn coil to see the magnetic field created at the center of the coil on CST simulation tool. The steps I followed are as below;
- I created a single turn coil which has 10cm diameter in low frequency domain.
- Then I cut very small part of it, and added current path with 1Amp.
- I select wire crosssection radius as 1cm.
- Then complated mashing and boundry things
- Later I simulated with 20khz.
The formulation to calculate magnetic field created at the center of coil is (Uo*I)/2*r
When I take Uo as 4*pi*10^(-7), I= 1amp, and r=0.05 meters I got the result of 12.566*10^(-6)
But when I run the simulation, I see that magnetic field created at the center is 9.03*10^(-6).
I attached the simulation file, please help me to find what could be the reason having different results.
Thank you