+ Post New Thread
Results 1 to 3 of 3

17th July 2019, 20:20 #1
 Join Date
 Jan 2018
 Posts
 183
 Helped
 1 / 1
 Points
 1,124
 Level
 7
Output power, Drain Current versus multipliers
Hi, I set Width(W) and Number of fingers (nf) for a transistor (in CS configuration) and found out it's drain current (Id) and output power (Pout)(Using HB simulation) for a particular load resistance(R). Now, If I want the output power 8 times that of Pout, is it just enough if I take 8 multipliers without changing R ? and does that mean Drain current (Id) is also increased by 8 times?.

Advertisement

18th July 2019, 14:52 #2
 Join Date
 Oct 2006
 Location
 Real Homeless
 Posts
 2,564
 Helped
 685 / 685
 Points
 16,695
 Level
 31
Re: Output power, Drain Current versus multipliers
Can you surely understand "Instance Multiplier" ?
No.
Can you surely understand "Impedance"and "Power" ?
Show me your definition of input power.
No.
Surely consider operation point, input and output impedance.
Surely learn and understand followings.
https://www.edaboard.com/showthread....anytechnoogy
https://www.edaboard.com/showthread....imeinSpectre
https://www.edaboard.com/showthread....delforMOSFETLast edited by pancho_hideboo; 18th July 2019 at 15:02.

Advertisement

18th July 2019, 15:59 #3
 Join Date
 Jan 2019
 Location
 Belgium
 Posts
 183
 Helped
 74 / 74
 Points
 1,260
 Level
 8
Re: Output power, Drain Current versus multipliers
You would get 8 times the drain current at DC no doubt. Now imagine you have managed to bias everything in class A. Then your current swing will be 8 times higher. 8 times current swing x same R > ideally you should get 8 times the voltage swing. But you will be limited by your supply voltage. Typically, a PA is designed such that at the peak point, your voltage swing amplitude equals the supply voltage (I assume you have used an inductance between the drain and supply). So for the same resistance, you will not get 8 times the voltage swing. You will clip and will end up with power in higher harmonics.
So, you need to change your input matching network so that you see 8 times lower resistance.
But that is not the end of it. Now because your transistor is 8 times larger, your capacitance will increase as well. For optimum power matching, you need to change the value of the capacitance and inductance.
In short, the answer is NO. Resources pointed out by pancho_hideboo are really excellent and you should go through them.
+ Post New Thread
Please login