Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

CST: strip line between

Status
Not open for further replies.
L

lufer17

Member level 5
Joined
Jul 15, 2019
Messages
84
Helped
0
Reputation
0
Reaction score
0
Trophy points
6
Activity points
885
CST
Hello everyone, I have doubts about '' g '' second link below. I did not find material on the subject. Where there are two openings in the antenna power line. (between the power line has spacing)

image001.gif

https://article.sciencepublishinggroup.com/journal/132/1321009/image001.gif
 

Hi,

I believe the parameter "g" is to get better antenna matching impedance. You can try to simulate the dimension of the parameter "g" & "d" by using CST.
 
To get the best compromise (impedance matching and radiated power), g should be about 1.5 x Wf.
 
felnet said:
Hi,

I believe the parameter "g" is to get better antenna matching impedance. You can try to simulate the dimension of the parameter "g" & "d" by using CST.
Click to expand...

Thanks, but can anyone indicate the book or material might better help develop this? I did not find good about it.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top