Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

help with speed control

Status
Not open for further replies.
D

dcntma

Newbie level 2
Joined
Nov 11, 2018
Messages
2
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
12
Hi, i have a 12 volt mini air compressor that i converted to use with engraver,, evrything turns on but when i try to connect a speed control to it ,,nothing?? i have tried different speed controls and still nothing? any help would be appreciated
 

Not enough information.
What motor does the compressor use?
How is it powered (12V DC, 12V AC or is it 12V from a power supply?)
What kind of speed controller, what are its ratings?

Brian.
 

Hi,

And what's the motor current rating?

Klaus
 

its a 12 volt 20 amps it plugs into a cigarette lighter and i was using a speed control from a tattoo power supply that supposed to go from 1.5 to 18volts
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top