Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

AD8619 Vol Measurement

Status
Not open for further replies.

chandlerbing65nm

Member level 5
Joined
Apr 5, 2018
Messages
80
Helped
0
Reputation
0
Reaction score
1
Trophy points
8
Activity points
709
Hi folks,

I have a dilemma here and I need help. In my knowledge, Vol is the measurement of DUT output wrt the negative supply. The passing limit of my Vol is 0-60mV. The typical is about ~40mV. But during my simulation in NI multisim, the value I get rails to 1.808. Hoping that somebody could help me on this.

Here is the configuration:
Vs = +/-0.9V
Il = 1mA
Vcntrl = >0.9V

The attached the config in multisim.
 

Attachments

  • ad8619SL.PNG
    ad8619SL.PNG
    48.2 KB · Views: 75

Hi,

What is "Vol"?
What is "DUT" in your circuit?
--> please use the same terminology as in the schematic.

We don´t see the complete circuit...
And your description is very vague...
We don´t know what you expect from the parts to work.
This makes it almost impossible to help.
***

Quite unusual for an OPAMP circuit ( U4A) is the missing negative feedback resistor. It may be correct or not.

Klaus
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top