Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

LTspice model for COB LED

Status
Not open for further replies.
T

treez

Guest
Hi,
Do you know how I can get a LTspice model for the LC019D and LC033D LEDs from Samsung?
Ie something that gives the same I,V curve when a DC sweep is done?
(pages 26,27 of datasheet)
**broken link removed**


(I am aware of using the "n" parameter to put LEDS in series)

I did the attached but its not accurate
 

Attachments

  • vf LC033D dc sweep I_test.TXT
    1 KB · Views: 64

The graph shows the LC019D conducting 1A at 37V.
Starting out with a simulation, I changed the led to that spec, but it makes the curve too steep (because the led equation is exponential). However by combining a series resistor, it makes the slope more linear and more gradual. I used trial-and-error. because it's not obvious how to derive an equation from the curve.

led 33V plus series 4 ohm resistor resemble hi-V led.png

The led conducts 1A @33V. The 4.4 ohm resistor adds another 4.4V @1A.
Over a range of 31 to 39V, current draw goes from 94mA to 1.3A. The curves are similar.
 
  • Like
Reactions: treez

    T

    Points: 2
    Helpful Answer Positive Rating
Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top