# Booster converter Circuit

1. ## Re: Booster converter Circuit

hahahahaha true sir

We were way to far from reality

Sir if someone asks your input is only 9V and output is less than that

2. ## Re: Booster converter Circuit

You could argue that 9V was only necessary to power the control circuits and they are relatively low power in themselves. It is true that if you could get enough power from the tree it would be possible to step the voltage up as you originally planned. The theory is good, the tree is the problem because it simply can't provide enough power to be usefully converted.

Brian.

2 members found this post helpful.

•

3. ## Re: Booster converter Circuit

Sir you are super !!
Thank you so much for helping me from the beginning!

Next time when we plan a new project i will make sure i will first discuss it with you sir

as we are going to wire it tomorrow

•

4. ## Re: Booster converter Circuit

Hello sir!!
We performed the experiment and the following are the results

From one tree:0.99V, 135mA
like this we connected 3 trees in series and the overall voltage was 1.12V and 116mA

And this we have given to the input to the booster converter and we got 5.54V and 48mA sir

We could glow and small led but not so much Bright.

•

5. ## Re: Booster converter Circuit

Your test results appear to prove the concept. The latest plan was to supply 9V power to the IC, but bring 'tree power' into the boost stage, correct?
Now if you truly took 1.1V @116mA tree power, then you can build a boost converter solely from tree power. Even if you illuminate one LED, that is a major achievement.

1 members found this post helpful.

6. ## Re: Booster converter Circuit

Okay sir
thank you

What can we do sir
to boost directly from the tree?

- - - Updated - - -

i searched net and i found out that they are MOSFET's whixh turn on for less voltage

shall we try that sir?

7. ## Re: Booster converter Circuit

and sir one more doubt
we are getting 48mA na sir
then led should glow brighter but in our case it was not brighter at all

8. ## Re: Booster converter Circuit

A plain red led should light when you apply 1.8v. (There are other colors but they require higher voltage.) It should conduct several mA. Do not allow more than 20 mA. Install a safety resistor if necessary. If the led is exposed to too great current, it can alter its operating characteristics, causing reduced efficiency, meaning it grows dim.

It's time to try building a boost converter which works from 1V power supply. Or else a voltage multiplier.

1 members found this post helpful.

•

9. ## Re: Booster converter Circuit

Sure sir we will connect a resistor to it.
thank you sir.

--[[ ]]--