Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

RS232 Spartan 3E testing

Status
Not open for further replies.

adwnis123

Full Member level 4
Joined
Jun 19, 2014
Messages
214
Helped
0
Reputation
0
Reaction score
1
Trophy points
18
Activity points
1,737
Hello,

I am trying to get the RS232 (connection between laptop and Spartan 3E) work.
I found these github links which I am trying to make them work and see something on the Serial. I use Termite here.
https://github.com/tvanas/uart-vhdl
https://github.com/uzairakbar/fpga-idea
Can someone tell me how I make it see some characters sent to/from my laptop (even encrypted/decrypted)??

Thank you
 
Last edited:

Hi,

You just need the correct setup on both sides....then most terminal software can show the HEX values.

Nothing special.


Klaus
 
Can someone tell me how I make it see some characters sent to/from my laptop (even encrypted/decrypted)??
Assuming your design is functioning properly, a common problem is baud rate matching.
Make sure the rate at VHDL UART and your PC console application is the same.
 
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top