Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

want to use Proteus make blocks missed parts why?

Status
Not open for further replies.

laoadam

Member level 2
Joined
Feb 22, 2019
Messages
52
Helped
0
Reputation
0
Reaction score
0
Trophy points
6
Activity points
324
I want to make the small parts of circuit into blocks, but not work, say three buttons make as one block, the result is missed other two.

post88.JPG
 

Not clear what you did, but the 'subcircuit-mode' feature is likely what you need:

 

Thank you.
Some times when I wiring device pin, it shown a red circle and refused, why?

POST89.JPG
 

Thanks.

Watched the video, can you tell hot to modify attached drawing's mcp4261 section into sub-circuit?

post90.png
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top