Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
A schematic of your setup would greatly help. Those are not necessarily floating signals - the edges seem very sharp. It could be two drivers clashing.
I rather think this rather shows a "short circuit" condition ... and not a "floating" condition.
(edit: just recognized that kripacharya already mentioned this)
.. and I agree with the others: we need more information.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.