Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

In PrimeTime, how can I report_delay_calculation from all input pins to all out pins?

Status
Not open for further replies.

majd229

Member level 2
Joined
Jul 21, 2017
Messages
44
Helped
0
Reputation
0
Reaction score
0
Trophy points
6
Activity points
392
Hello,
In the timing libs, I can find the "output" ports, see their "Related_pin", and report delay calculation from related_pin to output_port. However, how can I do this for all output ports and their related pins automatically?

Basically I receive a timing lib from a designer that I know nothing about (Except the lib itself) of a single cell, and I'm trying to find the delays from inputs to outputs, for whatever paths are available from each input to each output.

The other questio is, how can i find which paths are available?

Thank you
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top