Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

current sense of DC to DC

Status
Not open for further replies.
B

bbqsky

Junior Member level 2
Joined
Nov 18, 2004
Messages
22
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
197
I want to know which technic of current sense is most suitable for the current mode DC/DC converter. This DC/DC is used for portable application and require to have standby mode!
 

HI guys,

I am not sure that this project is any good for you. This project shows how to measure DC current (in the car) using a cheap Hall effect device and a ferrite core.

hxxp://www.siliconchip.com.au/cms/A_30551/article.html

30551_14mg.jpg


30551_10mg.jpg


HTH
 

Your question is not very clear.
If you are referring to how you sense the current in order to implement current mode control, then, depending on the power level, cost and control IC, you can choose between simple resistive sense and current transformer.

Please be more specific.
 

The DC/DC is used for mobilephone and it is implemented in a single chip

It converts the 3.6v battery voltage to 1.8v

The nomal operation load current is range from 50~200mA, when it comes to the standby mode, the load current required to output is only 100uA

I am designing a current mode CCM DC/DC, I donot know how to implement the current sense circuit suit for that application.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top