Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

MSP432+BLE+ Debugger interfacing

Status
Not open for further replies.
D

Devudu

Newbie level 1
Joined
Jun 14, 2019
Messages
1
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
14
Hi,

I would like to Interface a BLE to a MSP432 microcontroller in serial. The BLE has a inbulit Atmel controller. I have a firmware for BLE in keil. Intially I have flashed the firmware to BLE directly from a debugger and worked on the BLE. Now I should have a MSP432 in btween debugger and BLE.

I should flash the BLE via MSP432 in serial. I am planning to connect the hardware as below image. Is this way work out?. My another important question is I have to write the firmware for MSP432 and then combne the BLE code in to the MSP432 code?.

If so How can I send the perticuler BLE portion of code to the BLE?.

If I dont connect the seial pins of debugger to MSP432 how can I see the serial data on terminal in PC?.
 

Attachments

  • MSP432+BLE+Debugger.jpg
    MSP432+BLE+Debugger.jpg
    499.4 KB · Views: 45

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top