+ Post New Thread
Results 1 to 5 of 5
  1. #1
    Newbie level 1
    Points: 30, Level: 1

    Join Date
    May 2019
    Posts
    1
    Helped
    0 / 0
    Points
    30
    Level
    1

    There is a question about 'Stability of Integrator'

    Click image for larger version. 

Name:	aaaaa.jpg 
Views:	9 
Size:	272.3 KB 
ID:	153641

    I need a high performance integrator.
    And I want to check 'Stability of the integrator block'.
    So I designed it like the figure, and assigned it as the STB instance of SPECTRE at the place labeled VAC and simulated it.
    Loop gain and phase margin are shown in the figure.

    The area marked in red has a gain greater than 0dB.

    Should I only get the "phase margin" in red?
    If not, how should we check it?
    If you have any good documents, please share them.

    Thank you.

    •   AltAdvertisement

        
       

  2. #2
    Super Moderator
    Points: 257,296, Level: 100
    Awards:
    1st Helpful Member

    Join Date
    Jan 2008
    Location
    Bochum, Germany
    Posts
    44,888
    Helped
    13657 / 13657
    Points
    257,296
    Level
    100

    Re: There is a question about 'Stability of Integrator'

    The measurement seems to indicate about 90° phase margin and thus unconditional stability. STB setup looks correct.

    The measurement setup seems unreasonably simplified, where's the integrator input and input R. Apparently there's a zero in the loop gain, but no related R.



    •   AltAdvertisement

        
       

  3. #3
    Advanced Member level 5
    Points: 40,377, Level: 49
    Achievements:
    7 years registered
    LvW's Avatar
    Join Date
    May 2008
    Location
    Germany
    Posts
    5,784
    Helped
    1728 / 1728
    Points
    40,377
    Level
    49

    Re: There is a question about 'Stability of Integrator'

    The clasic MILLER integrator has a fedback capacitor and a serie resistor between integrator input and the inv. opamp terminal.
    Where is this resistor? Otherwise, the loop gain check is wrong!



    •   AltAdvertisement

        
       

  4. #4
    Advanced Member level 3
    Points: 9,195, Level: 22

    Join Date
    Nov 2001
    Location
    US
    Posts
    786
    Helped
    219 / 219
    Points
    9,195
    Level
    22

    Re: There is a question about 'Stability of Integrator'

    How do you provide bias to the negative input?



  5. #5
    Advanced Member level 5
    Points: 40,377, Level: 49
    Achievements:
    7 years registered
    LvW's Avatar
    Join Date
    May 2008
    Location
    Germany
    Posts
    5,784
    Helped
    1728 / 1728
    Points
    40,377
    Level
    49

    Re: There is a question about 'Stability of Integrator'

    At first, it is necessary to show us the complete circuit you are going to use.



--[[ ]]--