+ Post New Thread
Results 1 to 2 of 2
  1. #1
    Junior Member level 1
    Points: 142, Level: 1

    Join Date
    Feb 2019
    Posts
    15
    Helped
    0 / 0
    Points
    142
    Level
    1

    Connections diff probe

    Hello all,

    I am making an experiment with bldc motor with block commutation using back emf detection method. Here, I want to check the switching sequence of MOSFET’s using differential probe. Can anyone please tell me shortly about the procedure for viewing the all six MOSFET’s switchings using differential probe? I would like to know the question like Where to connect the differential probe and etc., to see three legs of MOSFET’s in b6 bridge.
    On my circuit board, i have six mosfet’s as it is b6 bridge.
    I want to make sure if these switching sequence match with expected commutation table.

    Thanks in advance

    •   AltAdvertisement

        
       

  2. #2
    Super Moderator
    Points: 74,693, Level: 66
    Achievements:
    7 years registered
    Awards:
    Most Frequent Poster 3rd Helpful Member

    Join Date
    Apr 2014
    Posts
    15,149
    Helped
    3448 / 3448
    Points
    74,693
    Level
    66

    Re: Connections diff probe

    Hi,

    First you need to know which signals you want to show.
    Maybe the six PWM signals...they usually are all referenced to the same GND...
    or the gate signals...
    or the motor signals...

    Klaus
    Please don´t contact me via PM, because there is no time to respond to them. No friend requests. Thank you.



--[[ ]]--