Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Connections diff probe

Status
Not open for further replies.

vishjay

Member level 2
Joined
Feb 1, 2019
Messages
42
Helped
0
Reputation
0
Reaction score
0
Trophy points
6
Activity points
306
Hello all,

I am making an experiment with bldc motor with block commutation using back emf detection method. Here, I want to check the switching sequence of MOSFET’s using differential probe. Can anyone please tell me shortly about the procedure for viewing the all six MOSFET’s switchings using differential probe? I would like to know the question like Where to connect the differential probe and etc., to see three legs of MOSFET’s in b6 bridge.
On my circuit board, i have six mosfet’s as it is b6 bridge.
I want to make sure if these switching sequence match with expected commutation table.

Thanks in advance
 

Hi,

First you need to know which signals you want to show.
Maybe the six PWM signals...they usually are all referenced to the same GND...
or the gate signals...
or the motor signals...

Klaus
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top