JAVAD_B
Newbie level 4
Hello,
I'm working with TSMC PDK and I faced a problem in abutment setting in the Layout L Editing.
However, when I use the Layout XL, The elimination of the contacts of the Drain/Source of two transistors which are connected to each other and i haven't any contact from them will do automatically but I cannot do that in the Layout L environment manually. I remove the contact of source or drain but the diffusion region of contact will remain. I did that several times in the other PDKs but this time I have this problem.
I would be appreciated if someone has any experience towards this in the TSMC PDK share it with me.
Thank you in advance!
I'm working with TSMC PDK and I faced a problem in abutment setting in the Layout L Editing.
However, when I use the Layout XL, The elimination of the contacts of the Drain/Source of two transistors which are connected to each other and i haven't any contact from them will do automatically but I cannot do that in the Layout L environment manually. I remove the contact of source or drain but the diffusion region of contact will remain. I did that several times in the other PDKs but this time I have this problem.
I would be appreciated if someone has any experience towards this in the TSMC PDK share it with me.
Thank you in advance!