Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Thermal vias in pads..plated over

Status
Not open for further replies.
T

treez

Guest
Hi,
Our PCB manufacturer offers us thermal vias in dpak pads, and plated over on top and bottom sides. They are filled with epoxy.
How come the air that must get trapped inside them doesnt get hot and explode out?
 

The epoxy fill is free of voids.
 
  • Like
Reactions: treez

    T

    Points: 2
    Helpful Answer Positive Rating
Don't fill them, its cheaper.
 
  • Like
Reactions: treez

    T

    Points: 2
    Helpful Answer Positive Rating
Don't fill them, its cheaper.
Fill and overplating are related. You can't have VIPPO without fill. The question is if VIPPO (the most expensive thermal via option) is actually required or standard open thermal via serves the purpose.
 
  • Like
Reactions: treez

    T

    Points: 2
    Helpful Answer Positive Rating
On critical jobs I have the plating done thicker, 0.035-0.050mm plating in the via... Generally mil/aerospace jobs, cheaper than plating.
 
  • Like
Reactions: treez

    T

    Points: 2
    Helpful Answer Positive Rating
Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top