Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

junk values in lcd connected to arduino

Status
Not open for further replies.

gayathrim

Junior Member level 3
Joined
May 13, 2019
Messages
25
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
253
hello, i'm trying to interface an lcd to an arduino and keypad. The keys of the keypad are connected to the arduino and prints values of keys and performs functions based on the key pressed. the arduino is coded using c programming in IDE software. however i've been getting junk values in the lcd. sometimes the code works just fine. sometimes the lcd prints junk values. i cant figure out whether the issue is caused by hardware or the code. kindly help. thanks in advance.
 

i cant figure out whether the issue is caused by hardware or the code.
Without seeing either its difficult to comment.
However, it sounds like a timing problem when the LCD is initialized.

Brian.
 

any rectification methods?
 

Hi,

please understand that we first need information before we can give solutions.

As far as we currently know.. my recommendation is:
Read the datasheet and follow the specifications.. acording data, sequence, timing....
If you do it this way, then the LCD will work correctly.

Klaus
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top