+ Post New Thread
Results 1 to 5 of 5
  1. #1
    Newbie level 1
    Points: 15, Level: 1

    Join Date
    Jun 2019
    Posts
    1
    Helped
    0 / 0
    Points
    15
    Level
    1

    PCB Netlist create in orcad16.6

    I have Updated schematic But netlist is not create How Can slove this type of error


    #1 ERROR(SPMHNI-175): Netrev error detected.

    ERROR(SPMHDB-195): Error processing 'U31': Cannot modify element; the object or a parent has the FIXED property. [help]

    •   AltAdvertisement

        
       

  2. #2
    Newbie level 4
    Points: 28, Level: 1

    Join Date
    Jul 2019
    Posts
    5
    Helped
    1 / 1
    Points
    28
    Level
    1

    Re: PCB Netlist create in orcad16.6

    Follow these rules, if the error persists then ask again:
     Assigning Footprints to Your Components
     Generate a PCB Editor Netlist in OrCAD Capture
     Set Up PCB Design and Draw a Board Outline
     Create and Place Mechanical Symbols
     Place your components manually or automatically in OrCAD
     Set Up Differential Pairs and Constraint Manager
     Create Copper Plane and Shapes
     Start Routing and perform DRC checks
     Setup fab drawings, dimensioning, title block, drill tables, cross section, and more.
     Produce and export manufacturing data, including drill information, gerber output, assembly drawings, solder and paste masks, and other essential documentation.



    •   AltAdvertisement

        
       

  3. #3
    Newbie level 4
    Points: 300, Level: 3

    Join Date
    Feb 2018
    Posts
    6
    Helped
    1 / 1
    Points
    300
    Level
    3

    Re: PCB Netlist create in orcad16.6

    You have the board file SNB_PSB.brd open whilst trying to create / import the netlist into it. TRy closing PCB Editor down and trying again OR uncheck the Netrev section of the netlist generator and once generated import it manually in PCB Editor from File - Import - Logic



    •   AltAdvertisement

        
       

  4. #4
    Newbie level 1
    Points: 14, Level: 1

    Join Date
    Aug 2019
    Posts
    1
    Helped
    0 / 0
    Points
    14
    Level
    1

    Re: PCB Netlist create in orcad16.6

    in addition to what RushPCBUSA said, also verify u31 is not fixed by entering placement edit mode, and right clicking on the component



  5. #5
    Advanced Member level 2
    Points: 5,545, Level: 17
    Achievements:
    7 years registered

    Join Date
    Dec 2006
    Location
    India
    Posts
    515
    Helped
    89 / 89
    Points
    5,545
    Level
    17

    Re: PCB Netlist create in orcad16.6

    Hi,

    You can select "ignore fixed property" tab while importing netlist.

    Regards



--[[ ]]--