Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Multiple Switching (class E) RF Power Amplifiers on one board

Status
Not open for further replies.
P

Politecnico

Member level 1
Joined
Aug 28, 2013
Messages
34
Helped
1
Reputation
2
Reaction score
1
Trophy points
8
Activity points
316
Hello everyone,

Does it technically make sense to have multiple Switching (class E) RFPAs operating at the same frequency (e.g. 10 MHz) for independent loads on the same PCB? What are the possible side-effects?
FYI, the circuit is designed for wireless power transfer, and so, no data are transmitted.

Thanks a lot, in advance!
 

having then too close may upset the control of each ... unless the RFI is well under control ...
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top