Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

CC1101 + SmartRF Studio + old AM HYBRID TRANSMITTER ?

Status
Not open for further replies.

berger.h

Member level 5
Joined
Sep 30, 2016
Messages
93
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,286
Activity points
2,355
I started playing with subject. More precise

I have cc1101 module any as this
for connecting with PC and SmartRF Studio 7 I use ccdebugger
ccdebugger and cc1101 module is detect in SmartRF Studio.

As transmiter I use wind sensor WS7000-15
this have 433.92MHz transmiter any as this and use this format of telegram

Frequency: 433.92MHz
Modulation: AM, I think OOK
data rate: 1200us/bit ==> 833.333 bit/s (baud)
bit coding: 0 800us Hi + 400us LO
1 400us Hi + 800us LO

In SmartRF studio I set
Base frequency : 433MHz (432.999817)
Xtal frequency: 26MHz (on module is 26MHz xtal)
Modulation: OOK
Channel number: 35 (I think center frequency 433.92MHz)
Datarate: 0.8333 (0.83375)
Channel spacing: 25kHz (25.390625)
RX filtr BW: 58.035714 kHz (defult)
because transfer is asynchronous I set PKTCTRL0.PKT_FORMAT=3


If I start in SmartRF Continuous RX I see noise, if touch on module noise increase, but I don't see the transmitter broadcast.
What I'm doing wrong?

cc1101.jpg
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top