Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

How to Set Correct Location for QUAD and MGT?

Status
Not open for further replies.

Port Map

Advanced Member level 4
Joined
Aug 24, 2013
Messages
118
Helped
15
Reputation
30
Reaction score
14
Trophy points
1,298
Activity points
2,089
Hi,
I have a kintex7 custom Board with xc7k410tffg676-2 device.

it has a connection to sata port.

MGTREFCLK0P_116/MGTREFCLK0N_116 is connected to a 200MHz ref clk(pin D6 and D5)

SATA data ports are connected to MGTXTXP0_116,MGTXTXN0_116, MG4 MGTXRXP0_116 and MGTXRXN0_116. (Pins F1,F2 , G3 and G4)

I read UG476_7series_transceivers.pdf but don't understand how to select correct Quad and GTX in wizard!
any one can help me?

what the below picture means? MGT_116 is quad 0 or 1?
which GTX is connected to MGTREFCLK0P_116/MGTREFCLK0N_116 pin?

Capture.PNG

picture below is the GTX wizard! did I select the correct locations for GTX and RefClks?

Capture2.PNG
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top