Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

How to show small-signal parameters in schematic in S-Edit TannerEDA?

Status
Not open for further replies.

melkord

Full Member level 3
Joined
May 18, 2018
Messages
150
Helped
0
Reputation
0
Reaction score
1
Trophy points
18
Activity points
1,751
Hello,

as the title says, I have seen some screeshots in this forum that near the MOSFETs, we can show voltage, ID, and maybe other values.
but they used other EDA.

In S-Edit, I can see many parameters by clicking the MOSFETs one-by-one and this is not efficient.
I can also shows voltages only or current only directly in schematic, but I have to choose between voltage and current, and no other values can be shown.

I put a screenshot to describe what I meant here.

Also, if anyone knows any internet forum for TannerEDA, please inform me if you dont mind.
the official support from mentor seems only for companies or parties that have support contract with them.

small-signal.PNG
 

Seriously ? Have you heard of a (little known ?) thing called Google ?

Check THIS out.
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top