ktr
Full Member level 3
Hello,
I am trying to incorporate a medium power PA into my circuit, which had only positive voltages before that. For this PA, I need to include a negative gate voltage for active bias purposes. What sort of practical difficulties are there for getting a negative voltage signal into my circuit?
My frequency is K-Band ISM, and the voltage value needed is -6Volts. I use Rogers4350 10mil as my PCB.
Waiting for an answer hopefully.
Best Regards,
ktr
I am trying to incorporate a medium power PA into my circuit, which had only positive voltages before that. For this PA, I need to include a negative gate voltage for active bias purposes. What sort of practical difficulties are there for getting a negative voltage signal into my circuit?
My frequency is K-Band ISM, and the voltage value needed is -6Volts. I use Rogers4350 10mil as my PCB.
Waiting for an answer hopefully.
Best Regards,
ktr