Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Application interface for Nvram

Status
Not open for further replies.
E

electronicsman

Full Member level 5
Joined
May 4, 2012
Messages
291
Helped
11
Reputation
22
Reaction score
12
Trophy points
1,298
Activity points
3,737
I have this clarification i want to write application interface for nvram. The doubt is does the application needs to know the eeprom address where he is writing? How to implement such a logic where the same application is reading the data, i should read from the same location. Any sample code available?
 

Hi,

what NVRAM are you talking about? Type, manufacturer, datasheet

The interface most probably will be SPI, I2C, parallel, ...

Please read the datasheet and in your next post please refer to the datasheet (page section...)


Klaus
 

...and I would add that unless this is a one byte NVRAM, yes, you need to be able to specify addresses.

Brian.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top