Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Any idea what brand make or model this connector this is chaps

Status
Not open for further replies.

audioelectrics

Newbie level 4
Joined
Nov 29, 2016
Messages
6
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
54
It is out of an unbranded device and I need to replace some that are broken.
 

Attachments

  • 20190502_110451.jpg
    20190502_110451.jpg
    418.4 KB · Views: 74
  • 20190502_110509.jpg
    20190502_110509.jpg
    171.5 KB · Views: 76
  • 20190502_110622.jpg
    20190502_110622.jpg
    441.2 KB · Views: 78
  • 20190502_110637.jpg
    20190502_110637.jpg
    431.9 KB · Views: 80
  • 20190502_110656.jpg
    20190502_110656.jpg
    172.6 KB · Views: 77
  • 20190502_110712.jpg
    20190502_110712.jpg
    483.7 KB · Views: 84
  • 20190502_110723.jpg
    20190502_110723.jpg
    454.4 KB · Views: 81
  • 20190502_110801.jpg
    20190502_110801.jpg
    456.5 KB · Views: 82
  • 20190502_110845.jpg
    20190502_110845.jpg
    263.6 KB · Views: 77
  • 20190502_110919.jpg
    20190502_110919.jpg
    444.1 KB · Views: 71

Is it a connector to a laundry iron or hot plate or coffee percolator? It looks like a type used in any number of appliances. The metal prongs are large as though designed to carry many Amperes.

I suspect manufacturers do not hold to any particular spec. It's unlikely you'll find a standardized dimension. Prong separations vary. Prong diameters vary. Etc.

In similar situations I imagine I could custom fabricate a duplicate connector, by slathering hot melt glue around two prongs held in the tubules of the opposite connector. Hot melt glue can be reworked, sculpted, built up, etc. However it breaks down when exposed to high temperatures or certain solvents.

It will be difficult to fabricate your own connectors the same way. In reality I'm inclined to make it easy on myself by clipping the connectors and simply splicing wires together.
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top