Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Why factory RESET comes during memory bootloading ? HW or SW issue ?

Status
Not open for further replies.

Hasan2017

Member level 4
Joined
Oct 23, 2017
Messages
76
Helped
0
Reputation
0
Reaction score
0
Trophy points
6
Activity points
831
Hi there,

I am working a WIFI module as follows,
**broken link removed**

To activate it, need to download 4 image file like Serial Flash Discoverable Parameter coverage.
At the same time I am using a USB to Serial COM port works in 5volt.
But, wifi module accepts 3.3v, so I am using TX, RX from USB Serial COM which has 3.3 level also.
To maintain 3.3 v for WIFI, an external power supply has used.

Not sure, after downloading why factory reset command appears ?
For voltage swing ?

In Serial terminal error massage says, :palm:

SETUP: ERROR(ret=9)

All services have been stopped.
Please reboot or setup again.

[PRADA:NVRAM] reboot

ERROR
PTIM is relocated to RETMEM (00184110)
RaLIB is relocated to RETMEM (00180810)
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top