Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Can I use a digital potentiometer replace the potentiometer in a buck converter board

Status
Not open for further replies.
Hi,

First you need the schematic of the module to know about the pot's signals (voltages and currents).
Then read the digital post's datasheet to get information about it's power supply requirements and signal limits.
How do you consider to generate the power supply?
Are the module voltages and currents all within the pot's specifications?

Klaus
 

Hi,

First you need the schematic of the module to know about the pot's signals (voltages and currents).
Then read the digital post's datasheet to get information about it's power supply requirements and signal limits.
How do you consider to generate the power supply?
Are the module voltages and currents all within the pot's specifications?

Klaus

Thank you.
The attached is the circuit of the LM2596 Adjustable Converter, there is no datasheet, don't how to figure out the pot's signals.

https://imgur.com/a/cvTG3Lw
 

Hi,

there is no datasheet
every IC and every electronic part comes with a datasheet.

don't how to figure out the pot's signals
Hopefully you can identify the pot in the linked schematic.
It is connected to the FB pin of the regulator --> look at the regulator datasheet about FB pin voltage
The other side is connected to the output voltage --> the output voltage range is given in the schematic

Klaus
 

It would be difficult to replace the potentiometer with a digital one in that schematic because of the high voltages it would have to endure. You could 'reverse' the feedback by swapping R1 and R2, it would at least let you ground reference the digital pot but it would work 'backwards' compared to the present position and to some degree sacrifice the ability to stabilize the output voltage.

A better method would be to use a DAC to drive the FB pin to set the voltage and also sense the output to maintain regulation.

Brian.
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top