Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

lcd display problem with unclear characters

Status
Not open for further replies.

mshh

Full Member level 6
Joined
May 30, 2010
Messages
349
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,296
Location
usa
Activity points
3,871
I have lcd 16*2 doesn't show characters clearly. to see it i have to look from sharp angle, i can't see characters when i look perpendicular. what is the problem?
Vcc=4.3v
 

Attachments

  • incubator.jpg
    incubator.jpg
    83.3 KB · Views: 78

Not sure if the display is designed to work with 4.3V single supply. The data sheet should tell. In any case, the circuit lacks a means to adjust Vee for best contrast.
 

Hi.

I agree, most probably VCC, the missing contrast circuit and thus the contrast may be the problem.

But also write timing may cause unclear characters. Thus I recommend not to (re)write a character more often than twice per second.

At least you may try this to see if something will change..

Klaus
 

The voltage of a LCD is critical if the 5V is down by only a few hundred milivolts can result in no display or very bad contrast on most displays. If you increase the supply voltage you will need a contrast control.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top