Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

How to combine 2 separate pin to 1 component in hyperlynx

Status
Not open for further replies.
Z

zereshki

Member level 1
Joined
Jun 15, 2008
Messages
39
Helped
1
Reputation
2
Reaction score
1
Trophy points
1,288
Activity points
1,627
Hi to all,
447813097_27692.jpg

In hyperlynx, how can I combine 2 separate pin as 1 component, like R, IC, C, terminal or ... .
in other words I want to merge H1 and H3 pins (atached photo) as one components.
At the moment, this pins are 2 separate pads(in hyperlynx are as pin) for out put of power supply.
The pcb file is imported from eagle.

thank you in advaced
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top