Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Building a heat gun out of hair dryer?

Status
Not open for further replies.
J

Javid.zare.s

Guest
hi fellas, since I know how a heat gun works and I have an extra hair dryer in house, im wondering if it possible to turn that into a heater that can be used to solder ---->SMD & chips<----
its written 2000watts on hair dryer (the other one is1200w and is way cooler that this one)
%D8%B3%D8%B4%D9%88%D8%A7%D8%B1-%D8%AC%D8%A7%D9%86%D8%B3%D9%88%D9%86-%D9%85%D8%AF%D9%84-%D8%B3%D9.jpg

p.s. I tried to decrease amount of air intake to get hot air out of it but not much success, whats wrong?
 

Wattage is one thing, where it goes is another. A heat
gun for soldering puts that wattage into a low flow air
stream for high temperature - temps that will melt any
cheapo consumer hair dryer.

Consumer dryers are made to prevent faults such as
inlet obstruction from burning lawsuit-happy American
idiot consumers. Probably internal bypass-air paths,
probably internal temperature switches that limit max
temp in fault conditions.

You can get cheap heat guns but these are often too
big for such work. The Nice Ladies In The Lab had tiny
ones with adjustable nozzles and probably only a couple
of hundred watts, for rework.

Might be best off looking on ebay for "surface mount
heat gun" and wait for the fluke low price buy-it-now.
 

    V

    Points: 2
    Helpful Answer Positive Rating
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top