Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Verilog-A $Strobe statement display in virtuoso

Status
Not open for further replies.
MahmoudHassan

MahmoudHassan

Full Member level 6
Joined
Oct 4, 2010
Messages
349
Helped
44
Reputation
90
Reaction score
40
Trophy points
1,328
Activity points
3,913
Hi
I am trying to use a strobe statement to implement the attached example in virtuoso. The example is using a $strobe statement to display the output report.
I don't know how can I get this report in virtuoso?

Capture.JPG
 

Virtuoso is a design framework.
There is no direct relation to Verilog-A.

Results are outputted in logfile of simulator.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top