Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Higher side lobe levels in linear array beam pattern

Status
Not open for further replies.

m_t_c

Junior Member level 3
Joined
Jun 30, 2007
Messages
25
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,540
Hi all

I am working on beam forming of high frequency (>400 KHz) linear array for imaging sonar. I have gathered sensor data of 80 channel linear array sub merged halfway in 8 m deep water tank with a transmitting probe 6 m away from it at same depth. I recorded multiple pulses and perform offline analysis on it. The problem i am facing is very high side lobe levels in a beam pattern developed using recorded data. Can any one kindly guide me what could be possible causes of higher side lobe levels?

Thanks & Regards
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top