Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Designing patch antenna fed through SMA cable

Status
Not open for further replies.
U

Unaz

Newbie level 6
Joined
Sep 3, 2009
Messages
13
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,375
I am feeding my patch through coax cable. I understand I will have to do so using an SMA Cable. My question is that how do I know which 50 ohm SMA to use. And also when I make the design in hfss should I make the hexagonal ring that most connectors seem to have? In all the figures I have seen the connector pin goes through the substrate and the plate touches the substrate instead of the ground plate. How do they fabricate that. Please respond soon
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top