student14
Member level 2
Hi
I am using Silterra 130nm for my low frequency analog design. Silterra doesnt provide I/O libraries. Can I use RFESDpads for my design. When I am using RFESDpads its providing good results after postlayout simulation. But Silterra says this I/O pads will not work for VDD and ground. As my post simulation layout is working fine with RFESDpads. Can I go for tape-out with this available RFESDpads. Any suggestions please.
Thanks
I am using Silterra 130nm for my low frequency analog design. Silterra doesnt provide I/O libraries. Can I use RFESDpads for my design. When I am using RFESDpads its providing good results after postlayout simulation. But Silterra says this I/O pads will not work for VDD and ground. As my post simulation layout is working fine with RFESDpads. Can I go for tape-out with this available RFESDpads. Any suggestions please.
Thanks