faraah
Newbie level 3
hello!
i am using a proteus 8 professional and i am simulating send-receive data (1 master-2slaves) using uart and i am using codevision avr for programming
an ldr is connected to each slave and connected with lcd
when i start simulation everything is ok and working but when i changing the value of ldr it can't displayed on lcd . if i stopped running simulation and started simulation again it's working but just for one time
can any one say to me where is the problem?
thnx alot
i am using a proteus 8 professional and i am simulating send-receive data (1 master-2slaves) using uart and i am using codevision avr for programming
an ldr is connected to each slave and connected with lcd
when i start simulation everything is ok and working but when i changing the value of ldr it can't displayed on lcd . if i stopped running simulation and started simulation again it's working but just for one time
can any one say to me where is the problem?
thnx alot