Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
It a kinda old version but I am guessing this is representing the number of modes that will be excited during your simulation.
The solver in CST starts with checking which modes exists in your waveguide and numbers them according to ther cutoff frequency. So mode one would be the fundamental mode of the waveguide. Mode 2, the one with the lowest cutoff above the fundamental and so on. If you set this number to >= 1 you will also simulate the coupling between the modes.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.