Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

[SOLVED] Connect rules are not found in your AMS installation? error

Status
Not open for further replies.

Chaoping

Newbie level 4
Joined
Apr 10, 2017
Messages
6
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
55
Screenshot from 2019-03-18 11-10-46.png
Screenshot from 2019-03-18 11-11-26.png
Screenshot from 2019-03-18 11-14-15.png
Screenshot from 2019-03-18 11-17-20.png
Screenshot from 2019-03-18 11-17-46.png

- - - Updated - - -

The path and root for connect_lib have been set as shown in the pictures. But the warning" connect rules are not found in your AMS installation" always come out when opening the connecting rules editor and after simulation.
Could you give me some pieces of advice?

Thanks a lot.
 

Maybe you must state the path to these rules somewhere in the ADE setup?
 

I found the reason. The connect_lib must be compiled before using.
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top