Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

UART Communication between 2.8V and 1.8V

Status
Not open for further replies.

aankur

Newbie level 5
Joined
Jul 23, 2014
Messages
8
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,362
I want to establish a UART communication between two modules. The Rx/Tx Voltage levels of the modules are 2.8V and 1.8V. Also, I have only 3.3V as the supply voltage on my board.

Kindly guide me as to how can I perform this level shifting.



Thanks
 

Hi,

this has been discussed many times. ... with varying voltage levels.

First find out V_OL and V_OH of the sending device and V_IL and V_IH of the receiving device.
Then do a search on "voltage level translation".

In detail the solution depends on: input currents, data rate, wire length, cost, size ....

Klaus
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top