Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Why lumped port must be at the boundary??

Status
Not open for further replies.

shashank451180

Newbie level 2
Joined
Feb 22, 2019
Messages
2
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
20
i have designed antenna in HFSS. but my lumped port is not touching boundary of substrate (2mm away from boundary), and still i'm getting proper results in simulation. but, when i change dimensions of feed and put lumped port at boundary then i'm not getting any results.
so, if i keep that port 2mm away, will there be any problem in fabrication??
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top