Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Reading Datasheet for TMG39931 I2C module

Status
Not open for further replies.
R

reco77

Junior Member level 1
Joined
Mar 30, 2018
Messages
19
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
184
Hi, I have been using TMG39931 and trying to detect the gesture of an object from one direction.


While going through the datasheet I was not able to understand mentioned below table parameters

Register/Bit Address Description
ENABLE<PON> 0x80<0> Power ON
ENABLE<AEN> 0x80<2> ALS Enable
ENABLE<AIEN> 0x80<4> ALS Interrupt Enable
ENABLE<WEN> 0x80<3> Wait Enable

In this table Enable<PON> is only reading the data or Writing the data?
Any suggestion on this will be a great help.
 

Hi,

My recommendation: Download datasheets always from the manufacturer internet site.

--> They are the most actual datasheets
--> There you will find additional informations, documents, links..

Klaus
 

It's all in the datasheet. Figure 44: Control Register Map tells which registers are R/W or read only.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top