Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

How do I verify Model(equation) using MATLAB for a CMOS circuit?

Status
Not open for further replies.

ANALA

Member level 1
Joined
Aug 7, 2017
Messages
33
Helped
0
Reputation
0
Reaction score
0
Trophy points
6
Activity points
264
I have a multiplier circuit simulated using LTspice..I would wish to verify new set of delay equations for the same multiplier circuit using MATLAB...How can I do this?
 

I want to verify the model for the same multiplier circuit...Most of the literature works have stated that model verification is done using MATLAB...So how do i verify the model?
 

I have a set of equations...Basically I want to verify these equations in MATLAB for a CMOS 8*8 multiplier.
 

The circuit has around 900 MOSFETs...So just running one equation wouldn't work...Then it would be the case of a simple CMOS inverter which has one PMOS and NMOS...
 

Can you understand MATLAB and Simulink correctly ?

They treat signal flow model not energy conservative model basically.
On the other hand, SPICE treat energy conservative model.

If you would like to treat energy conservative model, use Simscape of MATLAB.
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top