+ Post New Thread
Results 1 to 9 of 9

11th February 2019, 11:36 #1
 Join Date
 Feb 2019
 Posts
 2
 Helped
 0 / 0
 Points
 21
 Level
 1

Advertisement

12th February 2019, 13:44 #2
 Join Date
 Apr 2011
 Location
 Minneapolis, Minnesota, USA
 Posts
 12,878
 Helped
 2570 / 2570
 Points
 52,610
 Level
 56
Re: Three phase delta load problem
It's a lot to expect, for a student to understand immediately how power factor behaves, how the formulas are derived and how to apply them.
A simulation can further our understanding, now that we have computers. I recommend a simple circuit consisting of an inductor and resistor, powered from 240VAC 60Hz. (Later you can add the correction capacitor.)
Examine voltage and current waveforms.
In particular notice how the Ampere waveform does not coincide with the supply voltage waveform, but is delayed for a fraction of a cycle.
For load impedance your approach agrees with the solution. 6.144 ohmic and some inductive. In series their combined effect produces power factor 0.8.
I guess 6kW is the 'real' power consumed. At 240V this calculates to 25A in 9.6 ohm effective impedance (6.144 + a few ohms 'choke' effect of the inductor).
Notice that power factor=.9 requires less inductor.
Power factor =.7 requires more inductor.
Your third image seems to omit some of your own calculations.
To select pfc capacitor value, the aim is to achieve resonance with the RL load at 60 Hz. Then the Ampere waveform shall coincide with the supply voltage waveform. The real Ampere level can be minimized. It drops to 25A.
It helps to experiment with a capacitive load too. You can observe the advanced timing of the Ampere waveform as compared to the supply voltage waveform. Experiment by trying various RC combinations.
   Updated   
My above reply has to do with a single phase AC supply. It makes for a simpler learning environment. The exercise specifies a 3phase supply which creates complications.
1 members found this post helpful.

13th February 2019, 05:37 #3
 Join Date
 Feb 2019
 Posts
 2
 Helped
 0 / 0
 Points
 21
 Level
 1
Re: Three phase delta load problem
Thanks, Mr. Brad. Which software would be easy to simulate such problems i.e. three phase circuits?

Advertisement

13th February 2019, 09:40 #4
 Join Date
 Apr 2011
 Location
 Minneapolis, Minnesota, USA
 Posts
 12,878
 Helped
 2570 / 2570
 Points
 52,610
 Level
 56
Re: Three phase delta load problem
Falstad's animated interactive simulator is easy to draw schematics, add or remove components, change values, create scope traces.
Free to download and use at:
www.falstad.com/circuit
This is a 3phase 230VAC system. Scope traces tell the story. LED's light to indicate current flow.
1 members found this post helpful.

Advertisement

13th February 2019, 12:48 #5
Awards:
 Join Date
 Apr 2014
 Posts
 15,611
 Helped
 3557 / 3557
 Points
 77,053
 Level
 67
Re: Three phase delta load problem
Hi,
Thanks, Mr. Brad. Which software would be easy to simulate such problems i.e. three phase circuits?
Ltspice for sure...
KlausPlease don´t contact me via PM, because there is no time to respond to them. No friend requests. Thank you.

13th February 2019, 15:19 #6
 Join Date
 Nov 2012
 Posts
 3,128
 Helped
 768 / 768
 Points
 17,084
 Level
 31
Re: Three phase delta load problem
Can you please review and advise me
I_p=31.25/0acos(0.8)
where I use acos function as the inverse function as you have written.

13th February 2019, 22:47 #7
 Join Date
 Oct 2018
 Posts
 10
 Helped
 0 / 0
 Points
 210
 Level
 2

Advertisement

14th February 2019, 04:23 #8
 Join Date
 Apr 2011
 Location
 Minneapolis, Minnesota, USA
 Posts
 12,878
 Helped
 2570 / 2570
 Points
 52,610
 Level
 56
Re: Three phase delta load problem
It took a bit of searching to find his downloadable zip file since there are additional options to package the simulator.
Click the link below, then find the line which says: "Zip archive of this applet. (doubleclick on circuit.jar to run)" and click that.
http://www.falstad.com/circuitjava/
Or it may be sufficient simply to click this link:
http://www.falstad.com/circuitjava/circuit.zip
You need Java on your computer to run the applet. Java is a popular programming language. There are reports of hacker vulnerabilities in Java but updates are issued with the intent to eliminate these. It's a good idea to so some research to help you decide.
1 members found this post helpful.

14th February 2019, 13:42 #9
 Join Date
 Oct 2018
 Posts
 10
 Helped
 0 / 0
 Points
 210
 Level
 2
Re: Three phase delta load problem
Thanks mr BradtheRad
sorry for let you search to me
i will do my effort
thanks again
+ Post New Thread
Please login