Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Showing flash problem with LED lamp with TRIAC based on/off circuit

Status
Not open for further replies.
V

venkaty

Newbie level 1
Joined
May 10, 2018
Messages
1
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
14
We are doing home automation project in that we need snubber for both resistive and inductive load. If we connect less than 5W load(Bulb) it is keep on glowing without switch on. Whether i need to design a snubber for Low Watts? If so, Please Suggest the corresponding formula for design a snubber for different value of loads 0sj7s.png
 

Hi,

calculate the impedance of the snubber-C: Xc

(For ease of calculation you may neglect snubber-R)
Then you may calculate the "leakage" current flowing through your snubber.

Klaus
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top