Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

How do you trigger a triac?

Status
Not open for further replies.

boylesg

Advanced Member level 4
Joined
Jul 15, 2012
Messages
1,023
Helped
5
Reputation
10
Reaction score
6
Trophy points
1,318
Location
Epping, Victoria, Australia
Activity points
11,697
I have the following circuit with some minor variations:

triac.gif

AC voltage is 24V
Vg is 5V
R is 390 ohms
There is a solenoid valve in place of the lamp.
Triac is MAC97

But the circuit does not work regardless of whether I connect R to 5V DC or GND.
The triac won't turn on.

So how do you turn a triac on?
 

Please get the data sheet and find which is the guaranteed trigger current.
As is, you are supplying about 7 mA, and unless it is a sensible gate Triac, the trigger current may be 10 mA or higher.

Also, unless the Triac is specified for 4-quadrant operation (again look into the data sheet), the Triac will trigger better with minus 5 volts.
 

Should work with MAC97. Either the real circuit is different from schematic or the part is defective. Did you already check circuit voltages with a multimeter? What do you see?
 

Also;
make sure you have not swapped MT1 and MT2.....this is a common beginners mistake.
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top