Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Connecting node of component enlarged. How to correct it.

Status
Not open for further replies.

mnsnand

Newbie
Joined
Aug 2, 2017
Messages
5
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
31
Untitled.jpg

Connecting node of component enlarged in ads schematic. How to correct it. plz help!!!
 

From the schematic menus select Options > Preferences and then in the Pin/Tee tab set the require Pin & Tee Size setting. Normally these are set to the same values. The default setting is 0.05 "schem units" but these can be set to your preferred values.
 

thank you so much... it worked:wink::grin:
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top